This post walks through an illustrative prototyping scenario—not a measured customer case study. Consider a small team assembling a sensor-and-control prototype that still needs frequent layout changes before any production PCB.
Start with a shared mounting platform
In a typical iteration, the team wants one place to fasten breadboards, a microcontroller, power entry, and user controls so nothing slides around during firmware bring-up. Archive product listings describe JIGMOD platforms in M, L, and XL sizes, plus a JIGMOD Essentials Kit built around the XL Platform.
According to the archived Essentials Kit description, that kit included the XL Platform, two breadboards, a Binding Post JIGMOD, a Pluggable Terminal Block JIGMOD, a Tactile Button JIGMOD, a Thumbstick JIGMOD, fastener hardware, and complimentary LEDs, an LM35 temperature sensor, and a JIGMOD flashlight. That mix covers power connection, wiring breakouts, and basic HMI without custom brackets on day one.
Mount the controller with an adapter
The same archive notes that Arduino UNO/DUE/MEGA and Raspberry Pi (Model B and Model 3/B+) adapters fasten those boards directly to a JIGMOD platform, with the adapter kits including the listed screws and standoffs. In our illustrative workflow, that means the team can swap controller families without rebuilding the mechanical base of the bench.
Add peripherals as mountable modules
Product pages consistently stated that JIGMODs include four standoffs and four screws for mounting to a platform. Modules in the catalog covered switches, battery holders, proto board, connectors (USB, audio, RJ, SD, and others), and interfaces such as a Servo Interface JIGMOD. The team can relocate a button module or power entry without desoldering a one-off harness.
- Platform as the mechanical baseline
- Breadboard adapter or kit breadboards for still-fluid logic
- Controller adapters when the MCU or SBC choice is still open
- Catalog modules for power, HMI, and I/O that keep recurring
JIGMOD’s About page framed the system as helping people succeed at electronic product development. Used this way—as a reusable bench rather than a finished product enclosure—it compresses the usual cycle of remounting, rewiring, and re-fixturing between iterations. Browse current offerings on jigmod.com/shop.